* Hold mousbutton and move to rotate. Hold right right mouse button amd move to pan. Use mouse wheel to zoom.


After I printed this top I had the worst time getting it off my build surface. I ended up peeling off my tape to get it off! I designed it with tabs on it to help remove it from the table and it turned out they are too small and snapped of immediately.

If you can get a good spin it will spin for a long time since it is so heavy. Given the shape it prints with 100% infill no matter what your settings are so at 72mm it weighs in at 36 grams!

Discuss this model in the 3D-Printing-Community