Description

Again a new derivative for the X-Carriage Quick-Fit, but this time for LM10UU !!!

Almost keeping the previous design, I got a 9,3cm this time !!! not so bad for LM10UU.

I had to "improved" the Fan Quick-Mounts because keeping the 50mm spacing between rodes causes the fan holder crash in the bearings.

To keep the carriage as low profile as I can, I simply made fan mounts thicker, while you can hide nuts inside the fan mount !!!

Update June 15th:
- Fixed overlap in Support part.
- Added Belt clamp & latch (richrap one)
- Added a Fan mount for 30mm as the 40mm fans will probably crash between rods.

Discuss this model in the 3D-Printing-Community