* Hold mousbutton and move to rotate. Hold right right mouse button amd move to pan. Use mouse wheel to zoom.

Description

At Prototype.Asia, we rely extensively on Raspberry Pi computers, Arduino and FPGA prototyping boards to quickly develop and deploy working prototypes with a myriad of capabilities.

As some of our prototypes are destined to enhance the features of existing devices, we often need to deploy our prototypes in retrofitted devices, objects or places such as: televisions, refrigerators, lamp posts, chairs, doors, walls, etc. As such we needed a low profile and cost effective solution to securely mount these PCBs (Printed Circuit Boards) in a way that they would be both shielded from conductive surfaces and non-obtrusive the existing functions of purpose of the device, object or place.

We came up with the XCLIP, a fully parametrisable four corner PCB mounting solution which can be securely mounted on any flat surface without adding more than 2 mm in thickness to the total assembly.

The XCLIP is configured using four parameters: PCB length, width, thickness and component clearance; our XCLIP configurator generates an STL file which can be 3D printed in less than 25 minutes on either our FDM or PolyJet 3D printers (or on any other 3D printer as a matter of fact).

Design Fundamentals

While designing the XCLIP, we needed to ensure that it would provide a firm hold on the PCB without becoming over-engineered or bulky. Furthermore, we needed our device to have an increased retention force the further the PCB is pulled away from the mounting surface.

These features were achieved by centering the mounting plate and by using thin flexible arms to hold each corner of the PCB. When a force pulls on the PCB, the four corners slightly lift from the mounting surface, effectively reducing the plenary distance separating them, thus increasing the force they each exert towards the center of the PCB.

As the force reaches its maximum, the PCB becomes a structural element that limits the arms flex and transfers the load to the center mounting surface, which is held firmly in place by four M3 bolts (zip ties or double sided tape), thus ensuring that the PCB will remain in place.

Embed
Discuss this model in the 3D-Printing-Community