* Hold mousbutton and move to rotate. Hold right right mouse button amd move to pan. Use mouse wheel to zoom.


X Motor block and idler beefed up for LM6UU with 4mm slots for cable ties.

Not tried yet as busy,but tabs again broke even using Ryhs-jones carrier.

So added tie rap slots n lot more plastic ;)

Also widened channels for belts + widened M5 axis screw hole.

This was total redisgn from measuring original onto Alibre so dont blame me for errors (they happen)

update 12.05.13 Built it n problem with idler side added extra base depth n narrowed z axis hole 0.5mm, ohh added spacer for idler bearing too.. se ver 3

Discuss this model in the 3D-Printing-Community