Description

Felxible turtle, that can even go in her turte shell. Created by Egon

Instructions

It's a easy print and doesn't need support! There is a small pillar under the neck that you have to break or cut off after printing, this might be a bit tricky. I would also advise to use a brim to keep the different parts better in place while printing. I just printed one in 90 minutes with these settings: Print speed 50mm/s Bottom, outer wall and top 0.5mm Layer height 0.15mm Infill 25% with a speed of 75 mm/s If you want a really nice print, just lower the layer height.

Download flexible turtle 3D Model Files

Download all files


Info
Discuss this model in the 3D-Printing-Community